Accessories

One end connects to cut end of LED tape light. Barrel end plugs into 12VDC Pre-wired Power Supply. Clam-shell snaps shut for a secure connection. O...

Use this sturdy connector to tie in your low voltage LED lighting to one of our pre-wired power supplies End: Barrel connector (Fits reciprocating ...

Use this sturdy connector to tie in your low voltage LED lighting to one of our Splitters End: DC connector (Fits reciprocating DC Jack Female Conn...

Overall Length: 11"Each Leg Length: 5.5" 

Overall Length: 11"Each Leg Length: 5.5"Legs: 1-Female, 4-Males

To create a clean, finished product, mount LED tape light into this channel. Frost lens snaps into place. Length: 78"Dimensions: 9/16" Base x 1/4" ...

LED Arm Light Clamp opens to 1.75". Attach to flat wall panel or square bar.

LED Arm Light Clamp opens to 2.75". Attached to flat wall panel or square bar.

LED Arm Light Slides onto this clip. Clip screws down to hard wall

Molex end connects to the first Perimeter Light . Barrel end plugs into 24VDC Pre-wired Power SupplyOverall Length: 18"

6 Fixture Plug and Play Terminal Block for Adjustable Showcase Light Fixture. Includes Two-wire Lead.

6-Port Distribution BoxFunction: Plug up to 4 Fixtures into Distribution Box. DC Jack Plugs into 24VDC Pre-Wired Power Supply

Continuity loop used with the 350mA / 10 Watt Power Supply and Harness, if there are open ports in harness 

Use this controller with our RGBW Lighting.  RF Remote is slim, lightweight and easy to carry while receiver is small and easy to install. Remote t...

Now create a finished lighting product without limitations. Our new Flexible Channel and Lens allows the installer to bend around counters with a r...

Flexible Joiner allows user to join two strips of 3528 LED Tape Light with a separation of up to 6". Create corners, over gaps. Clam-shell snaps sh...

Direct join two strips of RGB LED Tape Light. Snap and locks shut for a secure connection. Dimensions: 13/16" Long x 1/2" Wide x 5/32" Tall  

Join two strips of RGB LED Tape Light. Snap and locks shut for a secure connection. Dimensions: 6-1/2" Overall Length (5-1/4" of Wire)  

Overall Length: 11"Each Leg Length: 5.5"Legs: 1-Female, 5-Males

Join two strips of RGB LED Tape Light at a 90° angle.  Snap and locks shut for a secure connection. Dimensions: 1-7/16" x 1-7/16"

Flexible Joiner allows user to join two strips of 5050 LED Tape Light with a separation of up to 6". Create corners, over gaps. Clam-shell snaps sh...

Join two strips of 5050 LED Tape Light. Snap and locks shut for a secure connection. Dimensions: 13/16" Long x 1/2" Wide x 5/32" Tall  

PrismUse this controller with our Luxor RGB Lighting.Includes cabling and connectors to match with the RGB Luxor Bars RF Remote is slim, lightweigh...